Hightower Custom Cues - Shop Tour - Page 3

Hightower Custom Cues

Shop Tour

Point and Inlay Equipment:

 

Our Cue Smith Inlay Machine. All cues from 1995 to 2004

were inlaid using this type of inlay machine. Before 1995

most were done using an old Gorton pantograph.

 

 

In 2004 we started using this CNC machine for doing

some of our inlay work. Both machines are very accurate,

but the CNC machine gives more flexibility in designs. It

also help cut down on the aching neck pain I get from

hours of leaning over the manual inlay machine.

 

 

This is our milling machine set up to cut v-groove points.

 

 

Various inlay slabs ready to be cut up and put in cues.

 

Belt sander with custom fence for truing up point squares

and another 101 uses. I use it in the off position to the

sand the back of inlays and tips.

 

<Previous   12345678910   Next>

 

 

 

 

 

 

© 2004 - 2017 Hightower Custom Cues
All Rights Reserved.
No part of this site may be used in any form without written consent of the owner.
For Technical Problems Please Email Support
Other Questions, Please visit the contact page.
Development by Deatherage Web Development